Thursday 28 August 2014

Split-ring resonators manufactured on conductive layer by selective laser ablation

Paweł Koziol ; Arkadiusz J. Antończak ; Patrycja E. Szymczyk ; Bogusz Stępak ; Łukasz Łazarek ; Michał R. Wójcik ; Michał Walczakowski ; Krzysztof M. Abramski

Abstract

In this paper an alternative method of manufacturing SRR structures through the selective removal of a thin layer of silver-palladium deposited on the surface of the Al2O3 ceramic by laser ablation process using nanosecond Nd:YAG laser (1064 nm) was presented. The SRR structures array were subject to transmittance measurements using the TDS (Time Domain Spectroscopy). Both electric and magnetic resonances were observed at frequencies determined by the structural parameters of the SRR. In case of the E field perpendicular to an SRR structure and one resonance area for 0.56 THz with the E field parallel to the structure, two characteristic resonant dips for 0.31 THz and 0.62 THz were obtained. Studies have confirmed that using selective laser removal process enables the preparation of the resonant structure in the range of THz. © (2014) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.


This study was performed using TeraView's Spectra 3000 system. (TeraView, Cambridge, UK)

Full Article: http://www.sciencedirect.com/science/article/pii/S0939641114002203

No comments:

Post a Comment